The adhesive disc hanger is also referred to as the invisible hanger.
It sticks to the back of the plate or dish, holds it flat and secure against the wall and cannot be seen.
The
Disc gives a permanent strong adhesion to a glazed or an unglazed
surface. A fixing that will not "age - harden" or deteriorate with time.
The hanger also has excellent adhesion to wood, hardwood and blockboard - ideal for hanging small pictures etc.
Available in 5 different sizes.
Suitable for items with a diameter between 2.5cm-40cm, 2"-16". Max weight 3kg
The disc comes attached to a firm backing card, along with a brass hook & pin. Instructions on application are provdied on the reverse of each card.
30mm/1" Adhesive disc plate hanger with brass hook
Suitable for items: 3.5cm-9cm, 1.5"- 3", Max weight: 500g
50mm/2" Adhesive disc plate hanger with brass hook
Suitable for items: 5cm-15cm, 2.5"- 6", Max weight: 1kg
75mm/3" Adhesive disc plate hanger with brass hook
Suitable for items: 7.5cm-20cm, 3"- 8", Max Weight: 2kg
100mm/4" Adhesive disc plate hanger with brass hook
Suitable for items: 12cm-30cm, 4.5"- 12", Max Weight 2.5kg
140mm/5" Adhesive disc plate hanger with brass hook
Suitable for items: 16cm-40cm, 5.5"- 16", Max Weight 3kg
Manfactured in the UK
Instructions:
Applying:
First clean the plate, (even if the plate is new, as surface contamination may inhibit adhesion).
Using
the fingers mix a little water into the glue on the adhesive side of
the disc and slowly agitate with your finger to activate the glue. Leave
for 5-10 minsutes until the glue becomes "tacky".
Apply the disc
to the back of the plate (ensure the hook is in the correct position
for plate design). Press down firmly and rub well to expel any air.
Leave to dry overnight.
Before hanging, test the strength of the adhesion by pulling firmly on the ring.
Removal:
The Disc removes completely in warm water and will not remove back stamps, glazes, or any other markings.
